LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 799 (Engine - 6.0L Diesel -- E350 & E450) >> General Procedures >> Cylinder Bore Honing >> Inspection

Cylinder Bore Honing: Inspection

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: There is no authorized repair for cracks in the cylinder block. If cracks are present, install a new cylinder block.
    NOTE: Do not substitute rubbing alcohol for wood alcohol.
  1. Inspect the cylinder block for cracks not visible to the eye.
    1. Coat the suspected area with a mixture of 25 percent kerosene and 75 percent light engine oil.
    2. Wipe the area dry, and immediately apply a coating of zinc oxide dissolved in wood alcohol. If cracks are present, the coating will become discolored at the damaged area.
scientia non olet · About LEMON Manuals