Connecting Rod Cleaning: Inspection
WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Using a suitable solvent, thoroughly clean the connecting rod and rod cap.
- Mark each connecting rod and its corresponding rod cap for correct installation.
- Measure the inside diameter of the piston pin bushing. Install a new connecting rod, if not within specification.
- Using a suitable micrometer, measure the connecting rod bearing bore.
- Remove the connecting rod bearings from the connecting rod and the connecting rod cap. Install the connecting rod cap onto the connecting rod and tighten the bolts.
- Further tighten the connecting rod cap bolts.
- Measure and record the connecting rod bearing bore as indicated. Install new connecting rods if not within specification.
- Using a suitable micrometer, inspect the connecting rod bearing bore taper.
- Measure the bearing bore inside diameter near the large chamfer.
- Measure the bearing bore inside diameter near the small chamfer.
- The difference between the two readings is the bore taper. Install new connecting rods if not within specifications.
- Measure the bearing bore inside diameter near the small chamfer.
- Measure the bearing bore inside diameter near the large chamfer.