LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 797 (Engine - 4.6L And 5.4L) >> Disassembly And Assembly Of Subassemblies >> Piston - Pin Connecting Rod, Press Fit >> Disassembly

Piston - Pin Connecting Rod, Press Fit: Disassembly

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the piston pin out from the connecting rod and piston assembly.
    Fig 1: Pressing Piston Pin Out From Connecting Rod And Piston Assembly
    G03885865Courtesy of FORD MOTOR CO.
  2. Remove the connecting rod from the piston.
    Fig 2: Removing Connecting Rod From Piston
    G03921070Courtesy of FORD MOTOR CO.
  3. Clean and inspect the connecting rod and piston. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
scientia non olet · About LEMON Manuals