LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 797 (Engine - 4.6L And 5.4L) >> Disassembly And Assembly Of Subassemblies >> Piston - Pin Connecting Rod, Floating Pin >> Assembly

Piston - Pin Connecting Rod, Floating Pin: Assembly

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Connecting rod must be installed into piston with identification markings toward front.
    Fig 1: Locating Identification Mark
    G03885869Courtesy of FORD MOTOR CO.
  1. Position the connecting rod in the piston.
  2. Lubricate the piston pin and pin bore with clean engine oil.
    Fig 2: Identifying Piston Pin And Pin Bore
    G03921072Courtesy of FORD MOTOR CO.
  3. Install the piston pin in the piston and connecting rod assembly.
    Fig 3: Installing Piston Pin Into Piston And Connecting Rod Assembly
    G03921073Courtesy of FORD MOTOR CO.
  4. Install the piston pin retaining clips in the piston.
    Fig 4: Identifying Piston Pin Retaining Clips
    G03885866Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals