LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 796 (Engine System-General Information) >> General Procedures >> Piston Ring-to-Groove Clearance

Piston Ring-to-Groove Clearance

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the piston for ring land damage or accelerated wear.
    Fig 1: Identifying Piston
    G03946841Courtesy of FORD MOTOR CO.
  2. Measure the piston ring-to-groove clearance.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
      Fig 2: Measuring Piston Ring-To-Groove Clearance
      G03885030Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals