LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 796 (Engine System-General Information) >> General Procedures >> Exhaust Manifold Cleaning and Inspection >> Procedure

Exhaust Manifold Cleaning and Inspection: Procedure

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces.
    2. NOTE: New exhaust manifold gaskets, nuts and/or bolts must be installed when an exhaust manifold is serviced.
    Fig 1: Checking Exhaust Manifold Sealing Surface For Warpage
    G03913726Courtesy of FORD MOTOR CO.
  2. Using the special tool (or a precision straight edge) and a feeler gauge, check the exhaust manifold sealing surface for warpage. If the warpage is greater than 0.76 mm (0.0299 in), install a new exhaust manifold.
scientia non olet · About LEMON Manuals