LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 796 (Engine System-General Information) >> General Procedures >> Connecting Rod to Crankshaft Side Clearance

Connecting Rod to Crankshaft Side Clearance

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the clearance between the connecting rod and the crankshaft. Verify the measurement is within specification.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
      Fig 1: Measuring Connecting Rod To Crankshaft Side Clearance
      G04003850Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals