Pinpoint Test C: No Power In Run

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

C1 CHECK THE IGNITION SWITCH
- Carry out the Ignition Switch Continuity Test. Refer to COMPONENT TESTING for component testing.
- Does the ignition switch test OK?
- Yes : GO to C2.
- No : REPLACE the ignition switch. REFER to IGNITION SWITCH . TEST the system for normal operation.

C2 CHECK THE VOLTAGE SUPPLY TO THE INTERIOR FUSE PANEL

Key in ON position.

Measure the voltage between the interior fuse panel and ground:

INTERIOR FUSE PANEL CIRCUIT SPECIFICATION

Interior Fuse Panel	Circuit
Fuse 8 (30A)	1499 (PK/LG)
Fuse 6 (10A)	1119 (RD)
Fuse 7 (10A)	687 (GY/YE)
Fuse 15 (5A)	297 (BK/LG)

Fig 1: Measuring Voltage Between Interior Fuse Panel And Ground

Courtesy of FORD MOTOR CO.

Are the voltages greater than 10 volts?

Yes : REVERIFY the concern. GO to SYMPTOM CHART .
No : If fuse 8 (30A) measures less than 10 volts, REPAIR circuit 1499 (PK/LG).

If fuse 6 (10A) measures less than 10 volts, REPAIR circuit 1119 (RD).

If fuse 7 (10A) measures less than 10 volts, REPAIR circuit 687 (GY/YE).

If fuse 15 (5A) measures less than 10 volts, REPAIR circuit 297 (BK/LG).

TEST the system for normal operation.