LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 792 (Steering Linkage) >> Removal And Installation >> Damper >> Removal

Removal And Installation: Damper: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the nut retaining the damper to the bracket on the steering linkage.
    Fig 1: Removing Nut Retaining Damper To Bracket On Steering Linkage
    G03884878Courtesy of FORD MOTOR CO.
    2. NOTE: The RH damper bracket and the steering linkage bracket can be removed from the vehicle, if necessary, by removing the retaining bolts and nuts.
    Fig 2: Removing Nut And Bolt Retaining Damper To RH Damper Bracket
    G03884879Courtesy of FORD MOTOR CO.
  2. Remove the nut and bolt retaining the damper to the RH damper bracket.
  3. Remove the damper from the mounting brackets.
    Fig 3: Removing Damper From Mounting Brackets
    G03884880Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals