Instrument Cluster Diagnostic Trouble Code (DTC) Index
WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford E450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) INDEX
| DTC | Description | Source | Action |
|---|---|---|---|
| B1202 | Fuel Sender Circuit Open | Instrument Cluster | GO to PINPOINT TEST B . |
| B1204 | Fuel Sender Circuit Short to Ground | Instrument Cluster | GO to PINPOINT TEST B . |
| B1205 | Reset Button Circuit Failure | Instrument Cluster | VERIFY that the instrument cluster bezel is aligned correctly and the SELECT/RESET button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . |
| B1317 | Battery Voltage High | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1318 | Battery Voltage Low | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1319 | Driver Door Ajar Circuit Failure | Instrument Cluster | GO to PINPOINT TEST W . |
| B1327 | Passenger Door Ajar Circuit Failure | Instrument Cluster | GO to PINPOINT TEST W . |
| B1342 | ECU Is Faulted | Instrument Cluster |
NOTE:
If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved again, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . REPEAT the self-test. |
| B1352 | Ignition Key-In Circuit Failure | Instrument Cluster | REFER to WARNING DEVICES . |
| B1360 | Ignition Run/Ace Circuit Open | Instrument Cluster | GO to PINPOINT TEST A . |
| B1607 | Illuminated Entry Input Circuit Failure | Instrument Cluster | REFER to INTERIOR LIGHTING . |
| B2143 | Non-Volatile Memory Failure | Instrument Cluster | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . REPEAT the self-test. |
| B2477 | Module Configuration Failure | Instrument Cluster | ATTEMPT to configure the instrument cluster again. If DTC B2477 is retrieved again, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . REPEAT the self-test. |
| B2658 | Wait to Start Warning Indicator Circuit Open | Instrument Cluster | CARRY-OUT the instrument cluster dealer test mode. If the wait to start indicator proves out normally, See INTRODUCTION - GASOLINE article . Otherwise, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . |
| B2982 | Park Brake Switch Input Circuit Open | Instrument Cluster | GO to PINPOINT TEST J . |
| P1139 | Water in Fuel Indicator Circuit Open | Instrument Cluster | See INTRODUCTION - GASOLINE article . |
| U0002 | High Speed CAN Communication Bus Performance | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |
| U1900 | CAN Communication Bus Fault-Receive Error | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |
| U2023 | Fault Received From External Node | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |