Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The rear wheel speed sensor ring is attached to the ring gear. It is necessary to remove the ring gear in order to remove the rear wheel speed sensor ring.

For additional information, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - DANA , REAR DRIVE AXLE/DIFFERENTIAL - FORD 8.8-INCH RING GEAR and REAR DRIVE AXLE/DIFFERENTIAL - FORD 9.75-INCH RING GEAR .