LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (Rear Drive Axle/Differential - DANA 60 And 70) >> In-Vehicle Repair >> Differential Housing Cover >> Installation

Differential Housing Cover: Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Clean the mounting surface on the differential housing cover and the differential housing with a suitable solvent to remove all traces of oil film.
    CAUTION: The differential housing cover uses silicone rubber sealant material as a gasket. Install the differential housing cover within 15 minutes of applying the silicone or it will be necessary to apply new sealant.
    Fig 1: Applying Sealant To Differential Housing Cover
    G03883432Courtesy of FORD MOTOR CO.
  1. Apply a continuous bead of silicone to the differential housing cover mounting surface.
  2. Assemble two bolts into the differential housing cover at the eight o'clock and two o'clock positions. Using these two bolts as a guide, position the differential housing cover on the differential housing.
  3. Install the remaining bolts. Tighten the bolts alternately and evenly.
    • Tighten grade 5 bolts to 47 Nm (35 lb-ft).
    • Tighten grade 8 bolts to 61 Nm (45 lb-ft).
      Fig 2: Identifying Differential Housing Cover Bolt
      G03883433Courtesy of FORD MOTOR CO.
    4. CAUTION: Allow 1-hour cure time before filling the axle with the correct amount of specified lubricant and operating the vehicle.
  4. Fill the differential housing with the specified type and amount of lubricant. For additional information, refer to SPECIFICATIONS .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals