LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 771 (Rear Suspension) >> Removal And Installation >> Wheel Studs - Semi-Floating Axle >> Installation

Wheel Studs - Semi-Floating Axle: Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not use air tools to install wheel studs or damage to the serrations can occur.

    All semi-floating axles 

  1. Position the wheel stud in the flange making sure that the serrations are aligned with those made by the original wheel stud.
    2. NOTE: Do not use a wheel nut that was removed from the vehicle.
    Fig 1: Installing Wheel Stud
    G03883229Courtesy of FORD MOTOR CO.
  2. Install washers and a wheel nut on the wheel stud and tighten the wheel nut until the wheel stud seats against the flange.

    3. Dana 60 semi-floating axles 

  3. Install the parking brake shoe adjusting screw.
  4. Install the parking brake shoe adjusting screw spring.

    5. All semi-floating axles 

  5. Install the rear brake disc.
  6. Install the rear disc brake caliper anchor plate. For additional information, refer to REAR DISC BRAKE .
scientia non olet · About LEMON Manuals