LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Controls - Powertrain DTC Charts & Description (Except Diesel & Hybrid)) >> Diagnostic Trouble Code (DTC) Charts And Descriptions >> DTC P1245: Generator Load Input Low

DTC P1245: Generator Load Input Low

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P1245 - GENERATOR LOAD INPUT LOW

Description:  The powertrain control module (PCM) monitors generator load from the generator/regulator in the form of frequency. The fault indicates the input is lower than the load should be in normal operation. The load input could be low when no generator output exists.
Possible Causes: 
  • GENRC circuit short to GND
  • GENLI circuit short to GND
  • Open B+ wire during operation
  • Low system voltage
  • Broken generator belt
  • Damaged generator/regulator assembly
  • Damaged PCM
Diagnostic Aids:  Verify the battery voltage is 14.5 volts.
Verify the generator/regulator has the correct part number.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to HY: Generator/Regulator System STEP HY1.
scientia non olet · About LEMON Manuals