DTC P0830: Clutch Pedal Switch A Circuit
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0830 - CLUTCH PEDAL SWITCH A CIRCUIT
| Description: | The powertrain control module (PCM) monitors the clutch pedal position bottom of travel (CPP-BT) switch only during the calibrated engine speed range (cranking speed range). This DTC is set when the CPP-BT switch does not indicate that the clutch is disengaged (clutch pedal pressed) when the engine is cranked. |
||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify that the vehicle was not push-started with the clutch engaged. Check for aftermarket equipment such as remote starting devices which may bypass the clutch pedal position switch when cranking the engine. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| F-150 4.2L | - | - | GO to TA: Clutch Pedal Position (CPP) Switch STEP TA1. |
| All others | Refer to STARTING SYSTEM to diagnose the symptom no start, no crank. | ||