Fuel Pump Driver Module (FPDM)

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2005 Mercury Sable, 2005 Mercury Mountaineer, 2005 Mercury Monterey, 2005 Mercury Montego, and 2005 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For the Thunderbird and LS, the FPDM functions are incorporated in the rear electronic module (REM). The fuel pump operation is the same as for applications using the stand-alone FPDM. The REM will, however, communicate diagnostic information through the communication link instead of using a fuel pump monitor (FPM) circuit.

NOTE: The Ford GT uses 2 FPDMs to control fuel for the dual-injection fuel delivery system. The PCM will output only one fuel pump duty cycle which is used by both pumps. The PCM will individually monitor the FPDMs through their fuel pump monitor circuits. Both FPDMs are mounted on the same bracket. The FPDM mounted in the upper position on the bracket is referred to as FPDM and the FPDM mounted in the lower position, is referred to as FPDM2.

The FPDM receives a duty cycle signal from the PCM and controls the fuel pump operation in relation to this duty cycle. This results in variable speed fuel pump operation. The FPDM sends diagnostic information to the PCM on the fuel pump monitor circuit. For additional information, refer to POWERTRAIN CONTROL MODULE (PCM) OUTPUTS , FUEL PUMP and POWERTRAIN CONTROL MODULE (PCM) INPUTS , FUEL PUMP MONITOR (FPM) .