P1451 - EVAP Control System Canister Vent Solenoid Circuit Malfunction
WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1451 - EVAP CONTROL SYSTEM CANISTER VENT SOLENOID CIRCUIT MALFUNCTION
| Description: | Monitors the canister vent (CV) solenoid circuit for an electrical failure. The test fails when the signal moves outside the minimum or maximum allowable calibrated parameters for a specified canister vent duty cycle by PCM command. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | To verify normal functioning, monitor the EVAP canister vent solenoid signal PID EVAPCV and the signal voltage (PCM control side). With the valve open, EVAPCV indicates 0% duty cycle and a voltage approximately equal to battery voltage. When the valve is commanded fully closed, EVAPCV indicates 100% duty cycle, and a minimum voltage drop of 4 volts is normal. Output test mode may be used to switch output on/off to verify function. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to HX: Evaporative Emission (EVAP) Monitor and System STEP 34 | ||