LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P1245 - Generator Load Input Low

P1245 - Generator Load Input Low

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1245 - GENERATOR LOAD INPUT LOW

Description:  The PCM monitors generator load from the generator/regulator in the form of frequency. The fault indicates the input is lower than the load should be in normal operation. The load input could be low when no generator output exists.
Possible Causes: 
  • GEN-COM circuit short to GND.
  • GEN-MON circuit short to GND.
  • Open B+ wire during operation.
  • Low system voltage.
  • Broken generator belt.
  • Damaged generator/regulator assembly.
  • Damaged PCM.
Diagnostic Aids: 
  • Verify the battery voltage is 14.5 volts.
  • Verify the generator/regulator has the correct part number.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to HY: Generator/Regulator System STEP 1
scientia non olet · About LEMON Manuals