LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P0722 - No Signal From The Output Shaft Speed Sensor

P0722 - No Signal From The Output Shaft Speed Sensor

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0722 - NO SIGNAL FROM THE OUTPUT SHAFT SPEED SENSOR

Description:  The output shaft speed sensor failed to provide a signal to the PCM upon initial movement of vehicle.
Possible Causes: 
  • Damaged OSS connector.
  • Damaged OSS sensor, or not installed properly.
  • Harness intermittently shorted or open.
Diagnostic Aids:  -
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Manual Transmission - - GO to TJ: Output Shaft Speed (OSS) Sensor Introduction STEP 1
All Others - - All Automatic Transmissions go to the appropriate AUTOMATIC TRANSMISSION article.