LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P0602 - Control Module Programming Error

P0602 - Control Module Programming Error

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0602 - CONTROL MODULE PROGRAMMING ERROR

Description:  This diagnostic trouble code (DTC) indicates a programming error within the Vehicle ID (VID) block.
Possible Causes: 
  • VID data corrupted by the diagnostic tool during VID reprogramming.
Diagnostic Aids:  Using the diagnostic tool, reprogram the VID block. If the PCM does not allow reprogramming of the VID block, reflashing the PCM is required.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All The Vehicle ID (VID) Block must reprogrammed. For instructions, refer to the Flash VID Block Procedure.
scientia non olet · About LEMON Manuals