P0455: EVAP Control System Leak Detected (No Purge Flow Or Large Leak)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.

P0455 - EVAP CONTROL SYSTEM LEAK DETECTED (NO PURGE FLOW OR LARGE LEAK)

Description:	The PCM monitors the complete EVAP control system for no purge flow, the presence of a large fuel vapor leak, or multiple small fuel vapor leaks. System failure occurs when no purge flow (attributed to fuel vapor blockages or restrictions), a large fuel vapor leak, or multiple fuel vapor leaks are detected by the EVAP Running Loss monitor test with the engine running (but not at idle).
Possible Causes:	After-market EVAP hardware (such as fuel filler cap) non-conforming to required specifications. Disconnected or cracked fuel EVAP canister tube, EVAP canister purge outlet tube, or EVAP return tube. EVAP canister purge valve stuck closed. Damaged EVAP canister. Damaged or missing fuel filler cap. Insufficient fuel filler cap installation. Loose fuel vapor hose/tube connections to the EVAP system components. Blockages or restrictions in the fuel vapor hoses/tubes (items also listed under disconnections or cracks). Fuel vapor control valve tube assembly or fuel vapor vent valve assembly blocked. Canister vent (CV) solenoid stuck open. Mechanically inoperative fuel tank pressure (FTP) sensor.
Diagnostic Aids:	Check for audible vacuum noise or significant fuel odor in the engine compartment or near the EVAP canister and fuel tank.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	-	GO to PINPOINT TEST HX: EVAPORATIVE EMISSION (EVAP) MONITOR AND SYSTEM Step 50.