LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P0400: EGR Flow Failure (Outside The Minimum Or Maximum Limits)

P0400: EGR Flow Failure (Outside The Minimum Or Maximum Limits)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0400 - EGR FLOW FAILURE (OUTSIDE THE MINIMUM OR MAXIMUM LIMITS)

Description:  The EEGR system is monitored once per drive cycle during steady state conditions above 77 km/h (48 mph). The test fails when a malfunction is detected by PCM calculations indicating the EGR flow is less or greater than expected.
Possible Causes: 
  • EEGR valve stuck open or closed.
  • Connector to EEGR not seated.
  • EEGR motor windings shorted or open circuit.
  • No power to the EEGR.
  • Harness open or shorted to power or ground.
  • Vacuum signal to MAP restricted or leaking.
  • MAF sensor signal erroneous.
  • Damaged PCM.
  • Carbon build up in the EEGR valve seat area.
  • One or more sensors is not responding or is out of range.
Diagnostic Aids:  All of the following sensors input data to the PCM for proper operation of the EEGR system: ECT, CPS, IAT, MAF, TP, MAP. Any DTC relating to these sensors must be resolved prior to addressing code P0400.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST KD: ELECTRIC EXHAUST GAS RECIRCULATION (EEGR) SYSTEM Step 9.