LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 743 (Engine Controls - Theory & Operation - 6.0L Diesel (99P E-Series & 99P F450/550)) >> Diesel On Board Diagnostics System >> Deviations From Standard Gasoline Implementation of OBD

Deviations From Standard Gasoline Implementation of OBD

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Readiness (i.e.: all monitors complete) is based on diagnostics for the following 6.0L diesel engine systems:
    • Comprehensive Component Monitor (CCM)
    • Misfire Detection Monitor
    • EGR Monitor

    The glow plug monitor is part of the comprehensive component monitor.

    Readiness is based on every OBD (component) having run sufficiently to have found a fault without regard to whether or not a fault exists.

  2. The DRIVE CYCLES is used to clear a P1000 code. The diesel system differs substantially from the gasoline system.
  3. The command to clear DTCs will ONLY clear P1000 if all drive cycle testing has been satisfied. All other detected DTCs will be cleared with a CLEAR code command from the scan tool if the fault that caused the DTC is no longer present.
scientia non olet · About LEMON Manuals