LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Automatic Transmission Servicing) >> Removal & Installation >> Solenoids >> Installation

Removal & Installation: Solenoids: Installation

WARNING: This page is about a different car, the 2002 Ford Ranger, 2002 Ford Explorer Sport Trac, and 2002 Ford Explorer Sport. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
  1. Install the new solenoid(s). Install the solenoid clamp. Position the solenoid clamp on the main control valve body. Install the solenoid clamp screws. Connect the 6 solenoid harness connectors.
  2. Connect shift solenoid harness connectors. See Figure . Connect the TCC solenoid harness connector. Connect the EPC solenoid harness connector.
    3. CAUTION: Excessive pressure may break the retaining pins.
  3. Install the main control valve body wire loom. Align the retaining pins to the holes in the solenoid clamps and gently press in the main control valve body wire loom guide and protector.
  4. Install transmission filter and oil pan. See DRAINING & REFILLING  under LUBRICATION. Lower the vehicle.
  5. Connect the negative battery cable. Fill the transmission with appropriate fluid to proper level and check for correct transmission operation. See LUBRICATION  .
scientia non olet · About LEMON Manuals