Gear Mode (Drive Mode)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, 2001 Ford RV Cutaway, and 2001 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Gear mode is used to test transmission shift functions. The OSC COMMAND VALUES allow for the following options:
- (1)
PCM selects 1st gear. - (2)
PCM selects 2nd gear. - (3)
PCM selects 3rd gear. - (4)
PCM selects 4th gear.
Perform the following procedure for GEAR MODE:
- Select OUTPUT STATE CONTROL.
- Select TRANS-DRIVE MODE.
- Select PIDs to be monitored.
- Monitor all selected PIDs during test.
- Select "Parameters - GEAR".
- Select OSC COMMAND VALUE 1-4, then press SEND.
- Re-select OSC value 1-4, then press SEND.
- Select "XXX", then press SEND at any time to cancel any command sent.