Removal & Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, 2001 Ford RV Cutaway, and 2001 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Remove any component necessary to gain access to Powertrain Control Module (PCM). For PCM location, see POWERTRAIN CONTROL MODULE LOCATION table. Loosen PCM harness connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting bolts (if equipped) or remove clip. Remove PCM cover and PCM. On Pickup, removal of fender liner may be necessary to slide PCM out. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
POWERTRAIN CONTROL MODULE LOCATION
| Model | Location | |
|---|---|---|
| Expedition & Navigator | Right Side Of Engine Compartment | |
| Econoline | Left Rear Of Engine Compartment, Near Master Cylinder | |
| Excursion | Behind Left Side Of Instrument Panel, Near Brake Pedal | |
| Pickup | ||
| F150 & F250 | Right Side Of Engine Compartment | |
| Super-Duty | Behind Left Side Of Instrument Panel, Near Brake Pedal | |