LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 729 (Engine - 6.0L Diesel - F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply Threadlock 262® to the outer circumference of the leading edge of the crankshaft.
    3. NOTE: New seal and wear sleeve must not be separated.
    Fig 1: Installing Oil Seal And Wear Sleeve Assembly
    G03899438Courtesy of FORD MOTOR CO.
  3. Using the special tool, install the oil seal and wear sleeve assembly.
  4. Install the crankshaft damper. For additional information, refer to CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals