LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 727 (Automatic Transmission - 5R110W) >> Diagnosis & Testing >> Diagnosis By Symptom >> Diagnostic Routines >> No 1st Gear in Manual 1 Position

No 1st Gear in Manual 1 Position

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC ROUTINE - NO 1ST GEAR IN MANUAL 1 POSITION

Possible Component Reference/Action
216 - ROUTINE 
Powertrain Control System 
  • PCM, vehicle wiring harnesses, transmission internal harness
  • Carry out on-board diagnostic tests. Refer to the appropriate INTRODUCTION article for diagnosis and testing of the PCM.
  • Carry out on-board diagnostic tests. Refer to the appropriate INTRODUCTION article for diagnosis and testing of the PCM.
External Shift Cable 
  • Cable system damaged, misaligned
  • Inspect and repair as necessary.
Incorrect Pressures 
  • High/low pressures
  • Check pressure at line tap.
Solenoid Body Assembly 
  • Bolts not tightened to specification
  • Tighten to specification.
  • Filter gasket damaged
  • Inspect for damage. If damaged, install a new filter gasket.
  • Contamination
  • Disassemble and clean.
  • Solenoid damaged, stuck or bore damaged; manual valve damaged, stuck or bore damaged
  • If damaged or parts are missing, install a new solenoid body assembly. If misassembled, reassemble correctly.
Coast Clutch Assembly 
  • Seals, piston damaged
  • Inspect for damage. Repair as necessary.
  • Friction elements damaged or worn
  • Inspect for damage. Repair as necessary.
  • Return springs damaged
  • Inspect for damage. Repair as necessary.
Overdrive Clutch Assembly 
  • Seals, piston damaged
  • Inspect for damage. Repair as necessary.
  • Friction elements damaged or worn
  • Inspect for damage. Repair as necessary.
  • Return springs damaged
  • Inspect for damage. Repair as necessary.
Overdrive OWC Assembly 
  • Worn, damaged or not assembled correctly
  • Inspect for damage. Repair as necessary.
Reverse Clutch Assembly 
  • Seals, piston damaged
  • Inspect for damage. Repair as necessary.
  • Filtered orifice damaged, missing, not seating, off location
  • Inspect for mislocation, poor seating, damage. Install a new case if damaged.
  • Friction elements damaged or worn
  • Inspect for damage. Repair as necessary.
  • Return springs damaged
  • Inspect for damage. Repair as necessary.
  • Snap ring for OWC and/or return spring not seated or damaged.
  • Inspect for damage. Repair as necessary.
scientia non olet · About LEMON Manuals