LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Engine 6.0L Diesel (99P E-Series & 99P F450/550)) >> In-Vehicle Repair >> Exhaust Manifold RH >> Installation

Exhaust Manifold RH: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.
    NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.
    NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.
    Fig 1: Right Exhaust Manifold Bolt Tightening Sequence
    G02764474Courtesy of FORD MOTOR CO.
  1. Install the RH exhaust manifold and bolts. Tighten the bolts in the sequence shown.
    2. NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.
    Fig 2: Installing RH Bolts For Turbocharger Adapter Pipe
    G02764475Courtesy of FORD MOTOR CO.
  2. Install the RH bolts for the turbocharger adapter pipe.
  3. Install the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals