Exhaust Manifold LH: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Fig 1: Installing LH Exhaust Manifold And Bolts

Courtesy of FORD MOTOR CO.

Install the LH exhaust manifold and bolts. Tighten the bolts in the sequence shown.
Connect the exhaust back pressure tube at the exhaust manifold.

Fig 2: Connecting Exhaust Back Pressure Tube
Courtesy of FORD MOTOR CO.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Fig 3: Installing LH Bolts For Turbocharger Adapter Pipe

Courtesy of FORD MOTOR CO.

Install the LH bolts for the turbocharger adapter pipe.
Install the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .