LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Engine 6.0L Diesel (99P E-Series & 99P F450/550)) >> In-Vehicle Repair >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

    ALL VEHICLES 

    CAUTION: To prevent engine damage, you must always install four new bolts when installing the vibration damper.
    NOTE: Do not use anti-seize compounds, grease or any lubricants. Lubricants have an adverse effect on the torque results.
    Fig 1: Crankshaft Vibration Damper Bolt Tightening Sequence
    G02764462Courtesy of FORD MOTOR CO.
  1. Install the crankshaft vibration damper and bolts and tighten in the following sequence, in three stages:
    • Stage 1: Tighten in the sequence shown.
    • Stage 2: Tighten to 68 Nm (50 lb-ft).
    • Stage 3: Tighten an additional 90 degrees.
  2. Install the accessory drive belt.
    Fig 2: Installing Accessory Drive Belt
    G02764463Courtesy of FORD MOTOR CO.

    3. VEHICLES WITH DUAL GENERATOR 

  3. Install the dual generator pulley and bolts.
    Fig 3: Installing Dual Generator Pulley And Bolts
    G02764464Courtesy of FORD MOTOR CO.
  4. Install the dual generator accessory drive belt.
    Fig 4: Installing Dual Generator Accessory Drive Belt
    G02764465Courtesy of FORD MOTOR CO.

    5. ALL VEHICLES 

  5. Install the cooling fan stator. For additional information, refer to ENGINE COOLING .
  6. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals