LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Engine 6.0L Diesel (99P E-Series & 99P F450/550)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the crankshaft front seal mounting surface.
  2. Apply Threadlock 262® to the outer circumference of the leading edge of the crankshaft.
    3. NOTE: New seal and wear sleeve must not be separated.
    Fig 1: Installing Oil Seal And Wear Sleeve Assembly
    G02764493Courtesy of FORD MOTOR CO.
  3. Using the special tool, install the oil seal and wear sleeve assembly.
  4. Install the crankshaft damper. For additional information, refer to CRANKSHAFT PULLEY .
scientia non olet · About LEMON Manuals