LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 723 (Rear Drive Axle/Differential - Ford 9.75-Inch Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Removal

Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pinion flange. For additional information, refer to DRIVE PINION FLANGE 
  2. Force up on the metal flange of the pinion seal. Install gripping pliers and strike with a hammer until the pinion seal is removed.
Fig 1: Removing Pinion Seal
G01440597Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals