LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 716 (Fuel System-General Information-Gasoline & Diesel) >> General Procedures >> Push Connect Fittings >> Disconnect

Push Connect Fittings: Disconnect

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and can be ignited, resulting in possible personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. Relieve the fuel pressure; refer to PRESSURE RELIEF  .
  2. Disconnect the safety clip from the male hose.
    Fig 1: Disconnecting Safety Clip From Male Hose
    G03462069Courtesy of FORD MOTOR CO.
  3. Install the fuel line disconnect tool and push into the fitting.
    Fig 2: Installing Fuel Line Disconnect Tool And Push Into Fitting
    G03462070Courtesy of FORD MOTOR CO.
  4. Separate the fittings.
    • Inspect for damage.
    • Clean the fittings.
    Fig 3: Cleaning Fittings
    G03462071Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals