LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 715 (Engine System - General Information) >> General Procedures >> Piston Inspection >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Service Tool
G03462000Courtesy of FORD MOTOR CO.
CAUTION: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can occur.
  1. Clean and inspect the (1) ring lands, (2) skirts, (3) pin bosses, and the (4) tops of the pistons. If wear marks, scores or glazing is found on the piston skirt, check for a bent or twisted connecting rod.
    Fig 2: Checking For A Bent Or Twisted Connecting Rod
    G03462001Courtesy of FORD MOTOR CO.
  2. Use the Piston Ring Groove Scraper to clean the piston ring grooves.
    • Make sure the oil ring holes are clean.
    Fig 3: Using Piston Ring Groove Scraper To Clean Piston Ring Grooves
    G03462002Courtesy of FORD MOTOR CO.