LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Safety Belt System - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Safety Belt - Front Bench Seat >> Removal

Safety Belt - Front Bench Seat: Removal

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the utility tray, if necessary.
  2. Disconnect and detach the driver safety belt switch.
    Fig 1: Disconnecting And Detach Driver Safety Belt Switch
    G02774703Courtesy of FORD MOTOR CO.
  3. Remove the safety belt bolts.
    1. Use the T-55 Torx bit to remove the safety belt buckle bolt.
    2. Use the T-55 Torx bit to remove the safety belt tongue bolt.
    Fig 2: Removing Safety Belt Bolts
    G02774704Courtesy of FORD MOTOR CO.
  4. Remove the safety belt.
    1. Remove the safety belt buckle.
    2. Remove the safety belt tongue.
    Fig 3: Removing Safety Belt Tongue
    G02774705Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals