LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Handles, Locks, Latches & Entry Systems -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Push Button Rod - Bellcrank, Rear Door, Crew Cab, Excursion >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Remove the rear door push button rod. Refer to PUSH BUTTON ROD - REAR, CREW CAB, EXCURSION .
  3. Remove the rear door push button rod linkage. Refer to PUSH BUTTON ROD - LINKAGE, HORIZONTAL, REAR DOOR, CREW CAB, EXCURSION .
    4. CAUTION: When drilling out the push button rod bellcrank rivet, do not oversize the hole in the door sheet metal.
  4. Remove the push button rod bellcrank.
    1. Remove the rivet mandrel (center).
    2. Drill out the rivet.
    3. Remove the push button bellcrank.
      Fig 1: Removing Push Button Rod Bellcrank
      G02774491Courtesy of FORD MOTOR CO.
    5. NOTE: Refer to SPECIFICATIONS  for the correct new rivet for the bellcrank.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals