LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 706 (Windows And Glass -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Rear Window Glass >> Installation

Rear Window Glass: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

    NOTE: Installation of the rear window requires an assistant to push the rear window glass into the rear window opening from outside the vehicle.
    Fig 1: Installing The Weatherstrip To The Rear Window
    G02774179Courtesy of FORD MOTOR CO.
  1. Install the weatherstrip to the rear window.
  2. Install the window installation rope on the cab interior side of the rear window weatherstrip ditch. Tie the window installation rope so that it slightly compresses the cab interior side of the rear window weatherstrip.
    Fig 2: Installing Window Installation Rope On The Cab Interior Side
    G02774180Courtesy of FORD MOTOR CO.
  3. Lubricate the rear window weatherstrip with soapy water.
  4. Position the rear window in the rear window opening.
    Fig 3: Positioning The Rear Window In The Rear Window Opening
    G02774181Courtesy of FORD MOTOR CO.
  5. Using the assistance of another technician outside the cab, seat the rear window glass and weatherstrip in the rear window opening.
    1. Pull the installation rope from the window weatherstrip (technician inside the cab).
    2. Push inward and downward on the rear window glass (technician outside the cab).

    Vehicles with power sliding window 

  6. NOTE: Left side is shown, right side is similar.
    Fig 4: Installing The Left Cable End Into The Sliding Window Trough
    G02774182Courtesy of FORD MOTOR CO.
  7. Install the left cable end into the sliding window trough.
  8. Install the left transition block on the cable end.
    Fig 5: Installing The Left Transition Block On The Cable End
    G02774183Courtesy of FORD MOTOR CO.
  9. Install the left transition block in the rear sliding window trough.
    Fig 6: Installing Left Transition Block In The Rear Sliding Window Trough
    G02774184Courtesy of FORD MOTOR CO.
  10. Install the left-hand cable swag into the rear sliding window.
    Fig 7: Installing The Left-Hand Cable Swag Into The Rear Sliding Window
    G02774185Courtesy of FORD MOTOR CO.

    SuperCab vehicles 

  11. Install the rear corner trim panels. Refer to INTERIOR TRIM AND ORNAMENTATION .

    Regular and Crew Cab vehicles 

  12. Install the rear trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .