Heated Seat Switch - With Seat Integrated Restraints (SIR): Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the heated seat switch into the trim panel, and connect the heated seat switch electrical connector.
- Verify the switch locking tabs are securely seated.
  
  Fig 1: Installing Heated Seat Switch Into Trim Panel
  Courtesy of FORD MOTOR CO.

CAUTION: Bend the side shield slightly to insure the shield is not scratched by the recliner lever.

Position the side trim cover and install the three trim cover screws.
- The seat backrest pivot bolt shaft must be inserted into the cover standoff.
  
  Fig 2: Installing Trim Cover Screws
  Courtesy of FORD MOTOR CO.
Push the rearward lower corner of the side shield to engage the metal retaining clip.
Position the lumbar adjuster control and install the two mounting screws. Install the adjuster knob.

Fig 3: Installing Adjuster Knob
Courtesy of FORD MOTOR CO.
Position the seat back recliner lever cover and install the screw.

Fig 4: Installing Seat Back Recliner Lever Cover Screw
Courtesy of FORD MOTOR CO.
Install the front seat. Refer to FRONT SEAT - WITH SEAT INTEGRATED RESTRAINTS (SIR) .
Repower the SRS. Refer to AIR BAG RESTRAINT SYSTEMS .