LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 702 (Body Panel System - Front End Body Panels -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Cowl - Vent Grille >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. For additional information, refer to WIPERS AND WASHERS .
  2. Remove the radio antenna mast.
    • Lift upward on cover.
      Fig 1: Removing Radio Antenna Mast
      G02773489Courtesy of FORD MOTOR CO.
  3. Remove the cowl top vent panel retaining screws.
    Fig 2: Removing Cowl Top Vent Panel Retaining Screws
    G02773490Courtesy of FORD MOTOR CO.
  4. Raise the hood (16612).
  5. Disconnect the windshield washer hose.
    Fig 3: Disconnecting Windshield Washer Hose
    G02773491Courtesy of FORD MOTOR CO.
  6. Remove the cowl panel weatherstrip.
    Fig 4: Removing Cowl Panel Weatherstrip
    G02773492Courtesy of FORD MOTOR CO.
  7. Remove and discard the cowl top vent panel pushpins.
    Fig 5: Removing Cowl Top Vent Panel Pushpins
    G02773493Courtesy of FORD MOTOR CO.
  8. NOTE: Remove the cowl top vent panel from the center to avoid damage to the locating pins at each outer end of the cowl panels.
    Fig 6: Raising Cowl Top Vent Panel
    G02773494Courtesy of FORD MOTOR CO.
  9. Raise the cowl top vent panel.
  10. Remove the cowl top vent panel.
  11. To install, reverse the removal procedure.