LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Exterior Lighting System -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Lamp Switch - Brake Pedal Position (BPP) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the brake pedal position (BPP) switch electrical connector.
    Fig 1: Disconnecting Brake Pedal Position (BPP) Switch Electrical Connector
    G02777886Courtesy of FORD MOTOR CO.
  3. Remove the BPP switch.
    1. Remove the self-locking pin.
    2. Remove the BPP switch from the brake master cylinder push rod.
    3. Remove the brake master cylinder push rod spacer.
    4. Remove the brake master cylinder push rod bushing.
      Fig 2: Removing Brake Master Cylinder Push Rod Bushing
      G02777887Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals