Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.

Remove the headlamp assembly.
1. Pull up and remove the two upper headlamp clips.
2. Release the lower headlamp clip.
3. Position the headlamp so the electrical connector can be accessed.
4. Disconnect the headlamp electrical connector.
  
  Fig 1: Disconnecting Headlamp Electrical Connector
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- If necessary, adjust the headlamps. Refer to HEADLAMP ADJUSTMENT .