LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 690 (Charging System - Battery, Mounting And Cables - Excursion & F250-F550 Super Duty) >> Removal And Installation >> Auxiliary Battery >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. Refer to BATTERY DISCONNECT - DUAL .
  2. CAUTION: Be sure the battery cover is reinstalled to avoid premature battery failure.
  3. Remove the battery cover.
    • Release the cable from the battery cover.
      Fig 1: Removing Battery Cover
      G02777734Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the battery hold down clamp.
    Fig 2: Removing Bolt And Battery Hold Down Clamp
    G02777735Courtesy of FORD MOTOR CO.
  5. WARNING: When lifting a battery, excessive pressure on the end walls could cause acid to spew through the vent caps, resulting in personal injury. Lift with a battery carrier or with your hands on opposite corners. Failure to follow these instructions may result in personal injury.
    Fig 3: Removing Battery
    G02777736Courtesy of FORD MOTOR CO.
  6. Remove the battery.
  7. To install, reverse the removal procedure.