LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Controls - Self-Diagnostics - EEC-V - Diesel 7.3L (99F E Series & 99F F450/550)) >> System Tests >> Test Dg: Barometric Pressure Sensor >> Testing

Test Dg: Barometric Pressure Sensor: Testing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Proceed to DTC testing steps listed in FAULT CODE SETTING CONDITION  table of fault code setting condition.
FAULT CODE SETTING CONDITION

Fault Code KOEO KOER Continuous Memory
P0107 1   DG1    DG3
P0108 1   DG2    DG4
(1)
For Federal emission models Malfunction Indicator Lamp (MIL) illuminates when fault is detected.
    NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  1. 1) KOEO DTC P0107: BARO Circuit Low Input
    This DTC indicates BARO sensor circuit low input was detected during KOEO on-demand self-test. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If DTC P0107 is present, BARO sensor is defective. Replace PCM. If DTC P0107 is not present, fault is intermittent. If DTC P0107 reappears, replace PCM.
    2. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  2. 2) KOEO DTC P0108: BARO Circuit High Input
    This DTC indicates BARO sensor circuit high input was detected during KOEO on-demand self-test. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If DTC P0108 is present, BARO sensor is defective. Replace PCM. If DTC P0108 is not present, fault is intermittent. If DTC P0108 reappears, replace PCM.
    3. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  3. 3) Continuous Memory DTC P0107: BARO Circuit Low Input
    This DTC indicates BARO sensor circuit low input was detected during normal operation. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If KOEO DTC P0107 is present, BARO sensor is defective. Replace PCM. If KOEO DTC P0107 is not present, fault is intermittent. If DTC P0107 reappears, replace PCM.
    4. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  4. 4) Continuous Memory DTC P0108: BARO Circuit High Input
    This DTC indicates BARO sensor circuit high input was detected during normal operation. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If KOEO DTC P0108 is present, BARO sensor is defective. Replace PCM. Clear DTCs and repeat QUICK TEST . If KOEO DTC P0108 is not present, fault is intermittent. If DTC P0108 resets, replace PCM.
scientia non olet · About LEMON Manuals