LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine Controls - Self-Diagnostics - EEC-V - Diesel 7.3L (99F E Series & 99F F450/550)) >> System Tests >> Test DF: Camshaft Position Sensor >> Diagnostic Aids

Diagnostic Aids

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

An inactive CMP signal during cranking is detectable by PCM and will cause a no-start condition. Electrical noise can also be detected by PCM and if noise level effects engine operation, a corresponding DTC will be set. Perform this test when directed by QUICK TEST. This test is only intended to diagnose the following components and circuits:

Fig 1: Identifying Camshaft Position Sensor Circuits & Connector Terminals
G99C02849Courtesy of FORD MOTOR CO.