LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 688 (Warning System -- Excursion & F250-F550 Super Duty) >> General Procedures >> Belt Minder Deactivating/Activating >> Deactivating/Activating

Belt Minder Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the RUN position. (Do not start the engine.)
  2. Wait until the safety belt warning lamp turns off (approximately 1 minute).
    3. NOTE: Step 3 must be completed within 60 seconds after the safety belt warning lamp turns off.
  3. Buckle then unbuckle the safety belt 9 times, ending with the safety belt unbuckled.
    • After step 3 is complete, the safety belt warning lamp will be turned on for 3 seconds.
    • If step 4 does not occur within 10 seconds at the end of step 3, the beltminder will automatically exit programming made without changing its enable status.
  4. Within 10 seconds of the lamp turning on, buckle then unbuckle the safety belt.
    • This will disable the beltminder feature if it is currently enabled. As confirmation, the safety belt warning lamp will flash 4 times per second for 3 seconds.
    • This will enable the beltminder feature if it is currently disabled. As confirmation, the safety belt warning lamp will flash 4 times per second for 3 seconds.
scientia non olet · About LEMON Manuals