Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable.
Remove the RH cowl side trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
Disconnect the electrical connector.

Fig 1: Disconnecting Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the inertia fuel shutoff switch.
1. Remove the bolts.
2. Remove the inertia fuel shutoff switch.
  
  Fig 2: Removing Inertia Fuel Shutoff Switch
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Fig 3: Connecting Electrical Connector

Courtesy of FORD MOTOR CO.