LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 673 (Transfer Case - Excursion & F250-F550 Super Duty) >> In-Vehicle Repair >> Transfer Case Shift Lever >> Removal

Transfer Case Shift Lever: Removal

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the transfer case into 4H.
  2. Remove the screws that attach the bezel and boot assembly to the floor.
    Fig 1: Attaching Bezel And Boot Assembly To Floor
    G02776737Courtesy of FORD MOTOR CO.
  3. Remove the bolt that attaches the shift lever to the transfer case control lever assembly, and remove the shift lever, and the bezel and boot assembly.
    1. Slide the bezel and boot assembly upward on the shift lever.
    2. Remove the bolt, the shift lever, and the bezel and boot assembly.
      Fig 2: Removing Bolt, Shift Lever, And Bezel And Boot Assembly
      G02776738Courtesy of FORD MOTOR CO.
    3. Raise and support the vehicle. Refer to JACKING & LIFTING .
    4. Disconnect the control rod from the lower shifter arm.
      Fig 3: Disconnecting Control Rod From Lower Shifter Arm
      G02776739Courtesy of FORD MOTOR CO.
    5. Remove the bolt and the transfer case control lever assembly. Discard the bolt.
      Fig 4: Removing Bolt And Transfer Case Control Lever Assembly
      G02776740Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals