LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Clutch System - F250-F550 Super Duty) >> Removal And Installation >> Flywheel >> Installation

Removal And Installation: Flywheel: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the flywheel.
    1. Install the guide studs.
    2. Install the flywheel and ring gear assembly, and the reinforcing ring.
    3. Install the bolts.
    4. Remove the guide studs. Install and tighten the bolts to specification.
    Fig 1: Installing Flywheel (6.0L)
    G02776374Courtesy of FORD MOTOR CO.
    Fig 2: Install The Flywheel (5.4L & 6.8L)
    G02776376Courtesy of FORD MOTOR CO.
  2. Restore the vehicle to operating condition.
    1. Install the clutch disc and pressure plate. Refer to CLUTCH DISC AND PRESSURE PLATE .
    2. Install the transmission. Refer to MANUAL TRANSAXLE/TRANSMISSION - ZF 6 SPEED .
scientia non olet · About LEMON Manuals