LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 666 (Automatic Transmission - 5R110W - Excursion & F250-F550 Super Duty) >> Specifications >> Band, Clutch, Solenoid, Switch Application

Band, Clutch, Solenoid, Switch Application

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear Direct Clutch PS-D (if equipped) SSPC-D Direct Clutch (6) Low Reverse Clutch PS-E (if equipped) SSPC-E Low Reverse Clutch (5)
P P - C LP/HA A(1)(3) C (1)(3) (1)
N N - C LP/HA A(1)(3) C (1)(3) (1)
R R A(5) O LP/HA(4) A(1) O(1) HP/HA(1)
OD with Tow Haul OFF 1 - C LP/HA A(1)(3) C (1)(3) (1)
OD with Tow Haul OFF 2 - C LP/HA - C LP/LA
OD with Tow Haul OFF 3 - C LP/HA - C LP/LA
OD with Tow Haul OFF 4(2) - C LP/HA - C LP/LA
OD with Tow Haul OFF 5 A O HP/LA - C LP/LA
OD with Tow Haul OFF 6 A O HP/LA - C LP/LA
(1) PCM Calibration Controlled
(2) Cold Strategy
(3) 207 kPa (30 psi) until mph reaches 5 km/h (3 mph)
(4) Clutch Applied Through Manual Valve Position
(5) Directly Proportional
(6) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear TCC Torque Converter (D) ODOWC L/R OWC
P P LP/LA X X
N N LP/LA X X
R R LP/LA X -
OD with Tow Haul OFF 1 (1) X X
OD with Tow Haul OFF 2 (1) O/R X
OD with Tow Haul OFF 3 (1) X O/R
OD with Tow Haul OFF 4(2) (1) O/R O/R
OD with Tow Haul OFF 5 (1) X O/R
OD with Tow Haul OFF 6 (1) O/R O/R
(1) PCM Calibration Controlled
(2) Cold Strategy
(3) Directly Proportional

O/R = Overrunning
LP = Low Pressure
LA = Low Current
X = Holding


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear Engine Braking Line Pressure PC-A(3) Forward Clutch Coast Clutch PS-A (if equipped) SSPC-A Coast Clutch (3)
P P - HP/LA(1) - - C LP/HA
N N - HP/LA(1) - - C LP/HA
R R - HP/LA(1) - A O HP/LA
OD with Tow Haul ON 1 Yes HP/LA(1) A A O HP/LA
OD with Tow Haul ON 2 Yes HP/LA(1) A - C LP/HA
OD with Tow Haul ON 3 Yes HP/LA(1) A A O HP/LA
OD with Tow Haul ON 4(2) Yes HP/LA(1) A - C LP/HA
OD with Tow Haul ON 5 Yes HP/LA(1) A A O HP/LA
OD with Tow Haul ON 6 Yes HP/LA(1) A - C LP/HA
(1) PCM Calibration Controlled
(2) Cold Strategy
(3) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear OD Clutch PS-B (if equipped) SSPC-B OD Clutch (2) Int. Clutch PS-C (if equipped) SSPC-C Int. Clutch (2)
P P - C LP/LA - C LP/LA
N N - C LP/LA - C LP/LA
R R - C LP/LA - C LP/LA
OD with Tow Haul ON 1 - C LP/LA - C LP/LA
OD with Tow Haul ON 2 A O HP/HA - C LP/LA
OD with Tow Haul ON 3 - C LP/LA A O HP/HA
OD with Tow Haul ON 4(1) A O HP/HA A O HP/HA
OD with Tow Haul ON 5 - C LP/LA - C LP/LA
OD with Tow Haul ON 6 A O HP/HA - C LP/LA
(1) Cold Strategy
(2) Directly Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear Direct Clutch PS-D (if equipped) SSPC-D Direct Clutch (6) Low Reverse Clutch PS-E (if equipped) SSPC-E Low Reverse Clutch (5)
P P - C LP/HA A(1)(3) C(1)(3) (1)
N N - C LP/HA A(1)(3) C(1)(3) (1)
R R A(4) O LP/HA(4) A(1) O(1) HP/HA(1)
OD with Tow Haul ON 1 - C LP/HA A(1) O(1) (1)
OD with Tow Haul ON 2 - C LP/HA A(1) O HP/HA
OD with Tow Haul ON 3 - C LP/HA - C LP/LA
OD with Tow Haul ON 4(2) - C LP/HA - C LP/LA
OD with Tow Haul ON 5 A O HP/LA - C LP/LA
OD with Tow Haul ON 6 A O HP/LA - C LP/LA
(1) PCM Calibration Controlled
(2) Cold Strategy
(3) 207 kPa (30 psi) Until mph Reaches 5 km/h (3 mph)
(4) Clutch Applied Through Manual Valve Position
(5) Directly Proportional
(6) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear TCC Torque Converter (3)/ OD OWC L/R OWC
P P LP/LA X X
N N LP/LA X X
R R LP/LA X -
OD with Tow Haul ON 1 (1) X X
OD with Tow Haul ON 2 (1) O/R X
OD with Tow Haul ON 3 (1) X O/R
OD with Tow Haul ON 4(2) (1) O/R O/R
OD with Tow Haul ON 5 (1) X O/R
OD with Tow Haul ON 6 (1) O/R O/R
(1) PCM Calibration Controlled
(2) Cold Strategy
(3) Directly Proportional

O/R = Overrunning
LP = Low Pressure
LA = Low Current
X = Holding


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear Engine Braking Line Pressure PC-A(2) Forward Clutch Coast Clutch PS-A (if equipped) SSPC-A Coast Clutch (2)
Manual Third 3 Yes HP/LA(1) A A O HP/LA
Manual Second 2 Yes HP/LA(1) A - C HP/LA
Manual First 1 Yes HP/LA(1) A A O HP/LA
(1) PCM Calibration Controlled
(2) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear OD Clutch PS-B (if equipped) SSPC-B OD Clutch (D) Int. Clutch PS-C (if equipped) SSPC-C Int. Clutch (D)
Manual Third 3 - C LP/LA A O HP/HA
Manual Second 2 A O HP/HA - C LP/LA
Manual First 1 - C LP/LA - C LP/LA
(1) PCM Calibration Controlled
(2) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The pressure switches listed in the band, clutch, solenoid, switch application chart will not be applicable to all vehicle applications. Some vehicles will not have the pressure switches installed in the valve body.
NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear Direct Clutch PS-D (if equipped) SSPC-D Direct Clutch (2) Low Reverse Clutch PS-E (if equipped) SSPC-E Low Reverse Clutch (1)
Manual Third 3 - C LP/HA - C LP/LA
Manual Second 2 - C LP/HA A O HP/HA
Manual First 1 - C LP/HA A O HP/HA
(1) Directly Proportional
(2) Inversely Proportional

HP = High Pressure
LP = Low Pressure
HA = High Current
LA = Low Current
A = Applied
C = Closed
O = Open


NOTE: The PTO may operate in any gear including PARK and NEUTRAL, does not require OD OWC. The TCC may engage in PARK and NEUTRAL with PTO engaged.
BAND, CLUTCH, SOLENOID, SWITCH APPLICATION

Range Selector Lever Position Gear TCC Torque Converter (2) OD OWC L/R OWC
Manual Third 3 (1) X O/R
Manual Second 2 (1) X O/R
Manual First 1 (1) X X
(1) PCM Calibration Controlled
(2) Directly Proportional

O/R = Overrunning
X = Holding